ここから本文です
TWO:
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:He gathered his courage for what he was going to say next, with a feeling almost of guilt. "Forbes says that I am doing you an injustice, keeping you here; that it is no life for you."

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:It ended in victory for the vinagrone, but he died from his wounds an hour later. Felipa told Landor so, as they started for a ride, early in the afternoon. "The vinagrone is dead," she said; "Mr. Brewster didn't like my fighting them." Then she assumed the lofty dignity that contrasted so oddly sometimes with her childish simplicity. "He lacks tact awfully. Think of it! He took the occasion to say that he loved me. As though he had not told me so a dozen times before."Crook had been recalled too late, and he knew it. Every Apache on the reservation was ready for the war-path. It was not to be averted. One man, even a very firm and deft one, could not straighten out in a few weeks the muddle of ten years of thievery, oppression, and goading. It takes more than just a promise, even though it is one likely to be kept, to soothe the hurt feelings of savages who have seen eleven of their friends jailed for fourteen months without the form of accusation or trial. They feel bitter toward the government whose minions do those things.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:Stone considered his dignity as a representative of the press, and decided that he would not be treated with levity. He would resent the attitude of the soldiery; but in his resentment he passed the bounds of courtesy altogether, forgetting whose toddy he had just drunk, and beneath whose tent pole he was seated. He said rude things about the military,—that it was pampered and inefficient and gold laced, and that it thought its mission upon earth fulfilled when it sat back and drew princely pay.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.